Search
Search Results
-
Electric Vehicle Modeling and Simulation of Volkswagen Crafter with 2.0 TDI CR Diesel Engine: VW Vehicle 2020 Based PMSM Propulsion
1-6Views:437The Internal Combustion Engine (ICE) used by conventional vehicles is one of the major causes of environmental global warming and air pollutions. However, the emission of toxic gases is harmful to the living. Electric propulsion has been developed in modern electric vehicles to replace the ICE.
The research is aimed at using both Simulink and SIMSCAPE toolboxes in a MATLAB to model the vehicle. This research proposes a Volkswagen (VW) crafter with a 2.0 diesel TDI CR engine, manufactured in 2020. An electric power train, a rear-wheel driven, based on Permanent Magnet Synchronous Motor (PMSM) was designed to replace the front-wheel driven, diesel engine of the VW conventional vehicle.
In this research, a Nissan leaf battery of a nominal voltage of 360 V, 24 kWh capacity was modeled to serve as the energy source of the overall system. A New European Drive Cycle (NEDC) was used in this research. Another test input such as a ramp was also used to test the vehicle under different road conditions. However, a Proportional Integral (PI) controller was developed to control both the speed of the vehicle and that of the synchronous motor. Different drive cycles were used to test the vehicle. The vehicle demonstrated good tracking capability with each type of test. In addition, this research found out that there is approximately about 19% more benefit in terms of fuel economy of electric vehicles than the conventional vehicles.
-
The Effect of Air-fuel Equivalence Ratio Change on the Vibration Components of an Internal-combustion Engine
1-6.Views:101Nowadays the automotive industry and the motor development are one of the most dynamically developing industries. One solution to the diagnostic systems providing reliability is the acoustic and vibration measurement system, which can indicate and predict a variety of malfunctions after signal processing. The purpose of this experiment is to analyze the effect of the air-fuel equivalence ratio on the vibration components of an internal-combustion engine (ICE) which is a part of the in question measurement system. In the focus of the experiments are the analysis of the time signal, its spectra, and the power content of the signal. With the increment of the air-fuel ratio the amplitudes of the measured signal and its spectral amplitudes showed a downward trend as the RMS values. In addition, certain frequency components disappeared during the actuation of the ICE with an electromotor, so the characterization of the combustion could be come to the front.
