Search

Search Results

• Modelling and comparing two canopy shapes using FEM

  71-74.

  Z. Láng

  L. Csorba

  Views:

  112

  Central leader and Vase form canopy models were built using FEM. Their main characteristics were chosen to be the same. The models were virtually exposed to the effect of steady-state horizontal forced vibration in the frequency range of 0-20 Hz. Acceleration-frequency curves were calculated and drawn to find the best frequency values for the effective detachment and also to see the acceleration differences in the limbs. For the same purpose the direction of shaking was also changed. It was found that for the Central leader canopy shape multidirectional shaking would bring uniform detachment while for the Vase form trees also the unidirectional shakers were appropriate. The acceleration achieved for the Vase form models were much higher than for the Central leader type. The acceleration-frequency curve of the shaker unit can be used to find the best frequency for shaking.

• Measuring the vibration of a brush cutter in different operation modes

  95-98.

  H. E. László

  Views:

  168

  The vibration load of a hand-held machine depends on many factors not defined in the ISO 5349:2001 standard about the measurements and evaluation of human exposure to hand-transmitted vibration. In this study, the effect of different operation modes on the vibration emission of a brush cutter was investigated. The frequency weighted r.m.s. acceleration was measured at the front (left) and rear (right) handle in three orthogonal directions according to ISO 5349 (2001). Two set of measurements were performed with three subjects for
  idling and cutting operations. In addition, the acceleration was measured with two holding positions, i.e. the cutting head is tilted by 45˚ to the left and tilted by 45˚ to the right. The standard vibration evaluation method, with the cutting head parallels to the ground, significantly under-estimated the vibration emission of the tilted tool to the left and right. The results suggest that the use of different holding positions would improve the reliability of the standard method of assessing the vibration of hand-held tools.