The impact of various grape stock cultivars on the As, Cu, Co and Zn content of the grape berry (must, seed)39-44Views:132
Scientific research from the last decades showed that the inappropriate industrial and agricultural production caused an abnormal increase of the potentially toxic elements in the soil. Unfortunately the acidification of the soil is an increasing problem in Hungary. According to Várallyay et al. (2008) 13% of the Hungarian soils are highly acid. Accumulation of toxic elements differs in the genetically diverse plant species. The root of the plant constitutes a filter so that the rootstock is also kind of a filter system, which may prevent that the scion part (such as berry) accumulate high levels of various potentially toxic elements from the soil. The aim of research was to determine how different grape rootstocks influence the As, Co, Cu and Zn content of the musts and seeds. Thus, specifying which of the grape rootstocks takes up the lowest level of these 4 elements (As, Co, Cu and Zn), and accumulates in berries, so could reduce the potentially toxic element load of the grape berries. The grape rootstock collection of the University of Debrecen was set up in 2003 in 3x1 m spacing on immune sandy soil. Grafting of ‘Cserszegi fűszeres’ was started in 2010. We could evaluate yields harvested from 12 rootstock varieties of the experiment in October 2011. We obtained valuable differences in the arsenic, copper, cobalt and zinc concentrations of musts and seeds of ‘Cserszegi fűszeres’ grafted into different rootstocks. The results obtained from the 2011 harvest support the statement that the choice of rootstock might be an important factor to increase food safety. The differences in concentration of the four elements observed in case of the rootstock may have been caused on one hand by the rootstock effect, and on the other hand, the vintage effect has a very significant impact on the vines element uptake. Several years of experimental results will be needed to answer these questions.
Spatial Relationships Between pH and Vegetation Pattern in an Area Contaminated with Heavy Metals140-143Views:73
It is not possible to gain information on the risk factor representing the bioavailability and the mobility of the contaminants only on the basis of their total concentrations. Especially, in case of heavy metals, which can be charaterised with very different chemical forms and their mobil and mobilizable parts are determined by complex balances highly sensitive to the changing environmental conditions. Considering mine tailings, however, the toxic elements are basically in ore forms having low adsorption capacity, thus the heavy metal ion concentration in solution is governed mainly by the pH conditions. In Gyöngyösoroszi, the spatial distribution of the total heavy metal concentrations as well as that of pH values determining the bioavailable part of the toxic elements were estimated and by mapping the vegetation pattern, relationship was analysed among the total Zn, Cu, Pb and As concentrations, the pH and the species present. Results show that the presence of the certain plant species is highly determined by the pH on the mine tailing material, the highest vegetation density was found where the bioavailability of the toxic elements were considered the smallest as a result of the neutral pH. As a result, high diversity could be found even in places where the total zinc, copper, lead and arsenic concentrations were extreme. In addition, plant species could be identified, which are tolerant to toxic elements and present even if the pH is low and the bioavailable part of the heavy metals is relatively high.
Relation of availability and barley uptake of some potentially toxic elements7-10Views:66
A small-plot microelement load field trial was set up on brown forest clay soil with eight elements (Al, As, Cd, Cr, Cu, Hg, Pb, Zn), on 3 levels each (0/30, 90, 270 kg element ha-1). The soil was treated with soluble salts of elements once at initiation (1994). In the seventh year of the experiment (2001) winter barley was the test plant. The total element content was determined in plant samples (shoot, straw, grain) after microwave digestion using cc.HNO3+cc.H2O2. The element composition of the prepared samples was determined using ICP-MS technique. In the experiment toxic effects of treatments and yield loss could not be observed. Zn and As contents in barely shoots were only moderately increased by increasing microelement loads. Effects of Cr, Cu, Hg, Pb and Al treatments could not be observed. On the other hand, Cd accumulation was significant in the shoot. Cd content was also increased both in straw and grain. Results of this experiment prove that Cd remains mobile in the soil-plant system for a long time. Its accumulation can be observed both in vegetative and reproductive parts of plants without toxic symptoms and yield loss.
Changes in toxic elements content of soil after sewage sludge treatment in energy willow plantation7-10Views:115
The primary purpose of our experiment was the solution of municipal excess sludge treatment by a renewable energy resource used willow (Salix viminalis L.) plantation. Tests were carried out to state whether the applied sewage sludge has caused any accumulation of the toxic elements in the studied soil layers, and - based on the results –to see whether the plantation is suitable for the treatment of municipal sewage sludge.
The excess sludge (sludge before dewatering) is beneficial for the willow, because it contains a 3–5% dry matter and therefore, a lot of water, too. This high water content ensures the high water amount needed for the intensive growth of the willow. On the other hand, the wastewater treatment plant can save the dewatering cost which corresponds to about 30% of the water treatment process costs. The amounts of the sprinkled sewage sludge were calculated on the basis of its total nitrogen content. Treatments were the followings: control, 170 N kg ha-1 year-1 and 250 N kg ha-1 year-1. The mean values of the toxic element concentrations in the sewage sludge did not cross the permitted limits of the land accommodating.
The measured toxic element values of the soil were compared to the limits of the 50/2001. (IV.3.) Government Regulation.The sprinkled sewage sludge on the bases of the total N content did not cause accumulation of heavy metals in the soil and the treated plants were also healthy without any signs of toxicity.
Toxic elemental content of Hungarian blaufränkisch wines87-90Views:144
Toxic elemental contents are one of the food safety risks in wines. Therefore International Organization of Vine and Wine (O.I.V.) defined the limit of some elements in it. Thirty Hungarian blaufränkisch wines were analysed by ICP-MS in order to determine the concentration of toxic elements. All wines are passed by the O.I.V limits to toxic element content (Cu, Zn, Cd, Pb) according to analysis. Copper is the only outlier in some samples, but they also did not overstep the limit. In the case of zinc the maximum is approximately fourth, in case of cadmium and lead the highest concentration is less than tenth and sixth of the O.I.V. limit, respectively.
Determination of the validation parameters of inductively coupled plasma mass spectrometer (iCP-mS): response curve linearity in the case of arsenic and selenium67-71Views:129
In the field of elemental analysis inductively coupled plasma mass spectrometers (ICP-MS) have the best sensitivity that means the lowest limit of detection, subsequently their applicability for the detection of essential and toxic elements in foods and foodstuffs is prominent. For the most elements could be measured the detection limit is between μg kg-1 (ppb) and ng kg-1 (ppt) e.g. for arsenic and selenium.
Considering an analytical task (sample type, analytes and their concentration, pretreatment procedure etc.) the applicability of an analytical method is determined by its performance characteristics. The purpose of validation is to ensure that the method would be used fulfills the requirements of the given task. In this article we describes one of the performance characteristics, the linearity, and the whole validation procedure aims measurement of arsenic and selenium in foodstuffs by inductively coupled plasma mass spectrometer (Thermo XSeries I.); but because of the limited number of pages the results are demonstrated only for arsenic.
The linearity of calibration was evaluated in three concentration ranges (0.1–1 μg l-1; 1–10 μg l-1; 10–50 μg l-1), with nine line-fit possibilities (without weighting, weighting with absolute or relative deviation; with or without forcing the curve through blank or origin) and different methods (graphical examination, correlation coefficient, analysis of variance).
The best method to ensure the linearity of correspondence between signal and concentration was the ANOVA test. In view of calibrations it was found that the range of 10–50 μg l-1 could be regarded as linear with four line-fit possibilities, and was non-linear between 0.1–1 μg l-1 and 1–10 μg l-1.
Effect of Copper, Zinc and Lead and Their Combinations on the Germination Capacity of Two Cereals39-42Views:401
The majority of researchers have studied the following group of microelements: B, Zn, Mn, Cu, Na, Co, Mo, I, Sn, Cl, Al, V, F, Cr, Hg, Cs, Li, Cd, As, Th, Rb, Cr, W, Ti, Sn, Se, Ba, Br. Sporadically, the following elements have been mentioned too: Au, Ra, Hg and Pb. In this study, the effects of copper treatments and their combination with zinc and lead microelements on the germination of maize and barley were investigated using different concentrations of these microelements. Six treatments were used: 1. Copper-sulphate (CuSO4) applied alone, 2. Zinc-sulphate (ZnSO4) applied alone, 3. Copper applied with zinc, 4. Lead-nitrate (Pb(NO3)2) applied alone, 5. Copper applied with lead and 6. Untreated control. Maize (Kiskun SC 297) and barley caryopsis were treated with copper and zinc solutions in the following concentrations: 0.03%, 0.003% and 0.0003%. Maize and barley caryopsis were treated with these solutions for 12 and 24 hours. Maize and barley caryopsis were also treated with lead solutions Pb(NO3)2 with different concentrations: 0.0005%, 0.005% and 0.05%. Maize and barley were treated with these solutions for 12 and 24 hours. In the combined treatments (3 and 5), the same concentration was used for each microelement as in treatments 1, 2 and 4. Control treatments were treated with water for both plant species. Our results showed that copper microelements significantly inhibit germination compared to the untreated control. The toxicity of copper is higher if concentration increases. Zinc microelements also inhibit germination, however its effect highly depends on the microelement concentration. Treatments of copper + zinc also inhibit germination. The two microelements applied together cause more phytotoxicity than they do alone. Lead is highly toxic to plants even in low concentrations. The toxic effect on germination dramatically increased when lead was applied with copper.
Effect of arsenic treatments on the element content of green peas203-208Views:179
The agricultural environment is contaminated with heavy metals and other toxic elements, which means more and more threats. One of the most important toxic element is the arsenic (As).
The objective of the study was to investigate the effect of As-treatments on the element content of the different parts of the green peas (root,stem, leaf, pod, pea) in the 4. phase of the plant development. Plants were grown in green house. Arsenic was applied in a form of arsenate (As[V]) and the plants were treated with 0, 3, 10, 30, 90 and 270 mg kg-1 arsenic.
According to the results the Ca content of root and pod was increased in the case of the 3 mg kg-1 As-treatment, after that decreasing tendency was observed. In the case of the 270 mg kg-1 As-treatment, the Ca content in the root was increased, because some element is able to concentrate in the lower biomass. The Ca-content of stem and leaves was reduced when the plants were treated with more than 30 mg kg-1 As. The lowest As-treatment (3 mg kg-1) increased the Na content in the root, stem and leaves, however in the case of the higher As-dose, decreasing tendency was observed. In the case of the generative plant parts the 3 mg kg-1 As-treatment also increased the Na content, nevertheless in the case of the higher As-treatments lower Na content was measured, however in the case of the highest As-treatment (270 mg kg-1) the Na content was increased in the generative plant parts, probably the Na was concentrated in the lower biomass. In the case of the 90 and 270 mg kg-1 As-treatment the Mo-content also was increased in the generative plant parts. The 270 mg kg-1 As-treatment caused a similar tendency in the case of the generative plant parts as a result of the lower biomass. In the case of the pod and leaves, the lower As-doses did not cause significant changes.
The Mo content was increased in the root and pea when the plants were treated with 3 mg kg-1 As, but in the case of the higher treatments it was decreased. In the case of the stem it was reverse, the lowest As-tretament (3 mg kg-1) decreased, nevertheless the further As-doses increased the Mo content.
Comparison of the sample preparation methods worked out for the examination of the element content of wine77-82Views:111
The examination of the potentially toxic elements content of the wines is not easy task, because the most elements are in little concentration (mg kg-1 or μg kg-1) in the wine and the wines contain great amount of organic matrix. The efficient sample preparation is essential for the accurate determination of element content. The eim of our research was to determine which sample preparation method will be the most efficient in examination of wines with ICP technology. The examined wine sample was a 2008 Chardonnay from the Eger wine region. We did the sample preparation and analysis examination in University of Debrecen, Centre for Agricultural and Applied Economic Sciences, Institute of Food Science, Quality Assurance and Microbiology.
We did the analysis examinations with ICP- MS (inductively coupled plasma mass spectroscopy). We always did the sample preparations and the examinations in three times rehearsal. The applied sample preparation methods: dilution with distilled water, open digestion and microwave digestion.
We were able to measure B, Al, Mn, Fe and Zn with only dilution and open sample preparation. In the smaller quantity present Sr and Ba were measurable in the wine in the case of all three methods well. We were able to measure the Co with dilution and open digestion method, while Cr, Ni, and Te with only dilution method. In the case of arsenic we were not able to measure reliable result with dilution and open digestion method because of organic matrix and other components
(alcohols, monosaccharides, polysaccharides, polyalcohols and inorganic salts). On the whole we are able to say that in the case of certain elements (B, Mn, Fe, Zn, Sr, Ba) the open digestion and dilution sample preparation is applicable well, however, in the case of certain elements (As, Al, V, Cr, Se, Mo, Cd, Hg, Pb) we have to develop the methods. It may be development of one of the way, if we develop sample preparation methods to examined element specifically and not
to wine generally.
History of origin and development of replacement of plants crop rotations is in world agriculture53-56Views:110
In practice of world agriculture a long ago the known problem of decline of harvests of agricultural cultures at their permanent growing, scientific explanation of this phenomenon became possible only with appearance of natural sciences. At first the declines of harvests bound to the toxic action of root excretions cultures on her repeated sowing, with development of humus theory of feed of plants of diminishing of harvests at the permanent sowing began to explain impoverishment of soil on a humus.