The effect of the preparation method on the physical and chemical characteristics of propolis tinctures163-168Views:220
The effect of the preparation method was examined with regards to the physical and chemical characteristics of the propolis tincture, namely the extraction time and the ethanol content of the extraction solvent to the dry matter, polyphenol, flavonoid, phosphorus, calcium and copper concentration, respectively. The dry matter, the polyphenol and the flavonoid content were the lowest in the water extract of the propolis; however, significant increase was noticed depending on the extraction time. Significantly higher concentrations were found in 50 V/V% tinctures. The highest dry matter and flavonoid contents were analysed in 100 V/V% tinctures, whereas highest polyphenol content was found in 80 V/V% tinctures. However, the differences were not significant in several cases between latter tinctures. Moreover, the increase was not determined in some cases depending on the extraction time. Phosphorus and calcium concentrations were decreased depending on the increasing ethanol content, whereas copper concentration was increased up to 80 V/V%. Higher increase was found in the case of 0 and 50 V/V% extracts than in 80 and 100 V/V% tinctures. Moreover, in latter cases, no significant differences were found on several occasions, depending on the extraction time. There was no connection between the flavonoids and the calcium as well as the phosphorus content, whereas flavonoids may be made complex with copper. However, the amount of the possible complex was negligible.
Effect of arsenic treatments on the element content of green peas203-208Views:179
The agricultural environment is contaminated with heavy metals and other toxic elements, which means more and more threats. One of the most important toxic element is the arsenic (As).
The objective of the study was to investigate the effect of As-treatments on the element content of the different parts of the green peas (root,stem, leaf, pod, pea) in the 4. phase of the plant development. Plants were grown in green house. Arsenic was applied in a form of arsenate (As[V]) and the plants were treated with 0, 3, 10, 30, 90 and 270 mg kg-1 arsenic.
According to the results the Ca content of root and pod was increased in the case of the 3 mg kg-1 As-treatment, after that decreasing tendency was observed. In the case of the 270 mg kg-1 As-treatment, the Ca content in the root was increased, because some element is able to concentrate in the lower biomass. The Ca-content of stem and leaves was reduced when the plants were treated with more than 30 mg kg-1 As. The lowest As-treatment (3 mg kg-1) increased the Na content in the root, stem and leaves, however in the case of the higher As-dose, decreasing tendency was observed. In the case of the generative plant parts the 3 mg kg-1 As-treatment also increased the Na content, nevertheless in the case of the higher As-treatments lower Na content was measured, however in the case of the highest As-treatment (270 mg kg-1) the Na content was increased in the generative plant parts, probably the Na was concentrated in the lower biomass. In the case of the 90 and 270 mg kg-1 As-treatment the Mo-content also was increased in the generative plant parts. The 270 mg kg-1 As-treatment caused a similar tendency in the case of the generative plant parts as a result of the lower biomass. In the case of the pod and leaves, the lower As-doses did not cause significant changes.
The Mo content was increased in the root and pea when the plants were treated with 3 mg kg-1 As, but in the case of the higher treatments it was decreased. In the case of the stem it was reverse, the lowest As-tretament (3 mg kg-1) decreased, nevertheless the further As-doses increased the Mo content.
Elemental content of propolis samples from Pest, Zala and Bács-Kiskun county (Hungary)149-153Views:201
The elemental content of 61 raw propolis samples from Pest, Zala and Bács-Kiskun county (Hungary) were analyzed by ICP-OES. The content of Al, B, Ca, Cu, Fe, K, Mg, Mn, Na, P, S, Sr and Zn were measured in the samples. Median is higher than mean in all cases based on the summarized results. It can be explained by the outliers, moreover it has a non-normal distribution. The concentrations are in an extremely wide range, the ratio of the maximum and minimum is under 10 in case of six elements, between 10 and 35.1 in the case of other six elements,and more than 300 in case of Zn. Significant differences are between counties only in the case of B, K and P based on ANOVA. Other elements have no significant differences. The following order can be set up based on the mean concentrations and the wide ranges: K≥Ca>P≥S≥Fe≥Mg≥Al>Zn≥Na>Mn≥B>Cu≥Sr. Moreover it can be established, that the measured concentrations are near the same or in some cases lower than in other publications.
Comparative analysis of sample preparation methods to determine the concentration of arsenic in soil- and plant-samples167-170Views:128
Arsenic contamination of the fields and groundwater is a global problem. Alföld is the most affected area in Hungary. Irrigation witharsenic contaminated water, and crop production on the contaminated soil can cause a food safety problem, because arsenic is easy taken up by the cell of the plant roots. To prevent this, very important to monitoring the arsenic content of soils and plants. Inductively coupled plasma mass spectrometry (ICP-MS) is a fast, easy method to determined the concentration of minerals in the case of plant and soil samples The analytical methods can give reliable, results if the analytical process, including the sample preparation method, is the best. The objective of this study was to compare 3 type of sample preparation method which was dry ashing, wet digestion in open system, and microwave digestion. As a result of our experiement shows the microwave digestion is the appropriate method to determined the arsenic content of soil samples. In the case of plant samples we can use wet digestion in open system or microwave digestion as a samle preparation method.
Toxic elemental content of Hungarian blaufränkisch wines87-90Views:144
Toxic elemental contents are one of the food safety risks in wines. Therefore International Organization of Vine and Wine (O.I.V.) defined the limit of some elements in it. Thirty Hungarian blaufränkisch wines were analysed by ICP-MS in order to determine the concentration of toxic elements. All wines are passed by the O.I.V limits to toxic element content (Cu, Zn, Cd, Pb) according to analysis. Copper is the only outlier in some samples, but they also did not overstep the limit. In the case of zinc the maximum is approximately fourth, in case of cadmium and lead the highest concentration is less than tenth and sixth of the O.I.V. limit, respectively.