Search
Search Results
-
Use of ANSYS Software for the Acetabular Cup Structure Analysis out of the Hip Implant
1-6.Views:338Modelling the hip implant has been one of the most important researches over the past few decades. In addition, using the ANSYS software for this purpose is well-known procedure to understand the real reaction of the hip implant parts during the daily life of the installed part. This study is to focus on the practical part of the use of ANSYS software to analyse the performance of the hip implant through the feature of structure analysis available in the ANSYS. The research applies the static loads behaviour only with the help of the static structural analysis to view the advantages and the disadvantages of every design, which helps us estimate the implant’s behaviour. The study investigates the optimization of the acetabular cup using the lattice optimization along with the infill option available in the ANSYS software in order to optimize the stress and the fixture of the cup inside the pelvis.
-
Parameter Estimation of Drag Coefficient and Rolling Resistance of Vehicles Based on GPS Speed Data
109-115Views:131In this paper, a parameter estimation method of the model-based design approach is applied to estimate the drag coefficient and the rolling resistance coefficient of a vehicle. In fact, a constant-force parameter (c_const) and a velocity-square-force parameter (c_square) are in the vehicle model, and these result in the sum force applied along the translational DOF that models the vehicle. It is only an assumption that the constant force is the rolling resistance and the force proportional to the square of the velocity is the drag force of the air. Only GPS speed data is used for the estimation process. The conclusion is that parameter estimation is a good alternative when expensive measurement devices are not available to measure the force losses separately and directly.
-
Self-developed Controller System –based on Open-Source Applications
97-105Views:77In the University of Debrecen Building Mechatronics Research Centre faced by the application of building automation technology, are tackled by cutting edge research performed at the Research Centre. The embedded device system, the focus of the ongoing project at the Research Centre, is programmable, reconfigurable, and adjustable. The design of an efficient embedded system must meet regulatory requirements, for optimizing building energy efficiency. The system provides solutions for a range of industrial applications, and peaks the interest of building services providers (e.g. SMEs).
-
Kinematics and Control of a Planar Cable Robot
88-95Views:122This paper deals with the kinematics and control of a planar cable robot [1], which is driven by four DC motors with gear. Cable robots are frequently used e.g., for the motion of cameras in sport halls and stadiums and also in high storage logistical systems [2]. Main goal of this research work is to design and build a test bench with low budget, which can model the motion of real life cable robots.
-
Experimental Study of Connections with Hardwood Studs
26-34Views:109Attitude change is needed in design of timber structures. Truss girder made of timber elements wi th small cross sections can be used on large spans. Constructing structures with the use of these prefabricated trusses reduces the need of in-site work, and makes the use of ti mber structures economic. Rods of truss can be connected with the use of hardwood stud. On this way all steel components can be eliminated from the truss, so it can be used in aggressive environment as well. Dowel type connection, with hard wood stud is the subject of the present research. Hardwood studs were investigated individually and also as the part of separated connections of the truss girder.
