Keresés

Keresési eredmények

• The Effect of annealing temperature on corrosion resistance and microstructure of Zr-Sn-Nb-Fe alloy

  420-424

  Zhao G.

  Tiba Zsolt

  Menyhárt József

  Megtekintések száma:

  126

  The Ti-2Al-2.5Zr titanium alloy plate in beta phase water quench at different times of the reentry after annealing is implemented while primary phase number and size distribution of samples are obtained. This research is carried out on corrosion behavior in 3.5% [mass fraction] NaCl solution. Experimental study showed that after the beta phase water quenching Ti-2Al-2.5Zr titanium alloyed after 500 oC annealing when partial recrystallization happened. There seems to be lots of tiny dispersion in the alloy that was annealed with its samples of six-party [HCP] structure of Ti, Zr, Al phase 2 with the dimension below 100 nm. Reaching 500 oC when the rate of annealing at a primary phase of the sample at 550 oC is low 90% of the primary phase is less than 100 nm. The changing of the rule of present decreasing also triggers little difference overall. Precipitation in the process of annealing Zr [Nb,Fe,Cr] 2is less that proves to be good for corrosion resistance.

• Optimization and Analysis of Structure about Lifting Device of Logistics Sorting

  425-431

  Zhao G

  Tiba Zsolt

  Menyhárt József

  Megtekintések száma:

  162

  The lifting device of a logistics sorting machine needs high frequency upward and downward reciprocating motion therefore the cutting fork arms and matching parts of the shaft are often worn out. In this paper the problem of the shear fork types applied for the lifting mechanism is studied at first. Then the advanced numerical simulation software ANSYS adopted for the lifting mechanism of the shear fork type, and the means of virtual simulation is introduced. Hence the possible location of faults and fault modes are analysed. Then improving measures about the lifting mechanism of the logistics sorting machine are suggested.