Search
Search Results
-
The influence of channel network silting up at Žitný Ostrov to range of interaction between surface and groundwater
23-31Views:109The movement of water resources, especially the possibilities of their regulation by interaction between surface and groundwaters are the subject matter of attention particularly during the occurrence of extreme hydrologic situation. This work presents the overview of knowledge and results which were achieved at IH SAS in this question. It can show the ways how to optimize the adjudicated processes which emerge during the requirement of emergency intervention. The solution of this task was located at the Žitný Ostrov area because this territory with their existence of channel network is suitable for studying the surface and groundwater interaction. The channel network at Žitný Ostrov was built up for drainage and also to safeguard irrigation water. The water level in the whole channel network system has an effect on groundwater level on the Žitný Ostrov and vice versa. It was been necessary to judge the impact of the channel network silting up by bed silts on the interaction between channel network and groundwater on the Žitný Ostrov. The aim was to evaluate the changes of bed silt state of Žitný Ostrov channel network and consecutively their influence on interaction processes between groundwater and surface water along the channels in the period from 1993 to present. The measurements of bed silt thickness in Žitný ostrov channel network had been started from1993, later they continued at selected profiles of three main channels – channel Gabčíkovo-Topoľníky, Chotárny channel and Komárňanský channel (for checking of the silting up variability). From 2008 the detailed field measurements of cross-section profiles aggradations along these selected three channels have been started. The objective of detailed field measurements was the determination of the silt permeability which is expressed by parameter of saturated hydraulic conductivity. This parameter was determined by two ways – as the saturated hydraulic conductivity obtained from disturbed samples of silt Kp and as the saturated hydraulic conductivity obtained from undisturbed samples of silt Kn. In the first case the granularity of silts was determined as a first step and then was computed their Kp from the empirical formulas according Bayer-Schweiger and Spacek. From undisturbed samples of silts which were extracted along the channels from top, middle and bottom layer of silts, were determined the values Kn by the laboratory falling head method. The valid values Kp on channel Gabčíkovo-Topoľníky ranged from
4,33 10-7 to 4,46.10-5 m s-1, on Chotárny channel from 5.98 10-5 to 2.14 10-6 m s-1 and on Komárňanský channel fluctuated from 1.93 10-6 – 6.09 10-5 m s-1. The valid values Kn on on channel Gabčíkovo-Topoľníky ranged from 5.21 10-8 – 4.18 10-3 m s-1 , on Chotárny channel ranged from 8.54 10-8 – 2.70 10-4 m s-1 and on Komárňanský channel fluctuated from 4.72 10-7 – 1.26 10-5 m s-1. The remarkable results were noticed by comparison of values of saturated hydraulic conductivity from disturbed and undisturbed samples Kp and Kn. On Chotárny channel the values of silt saturated hydraulic conductivity from undisturbed samples Kn approximately hundredfold decreased (from 10-6 to 10-8 m s-1). On Komárňanský channel the comparison of values Kp and Kn shown that the values Kn from undisturbed samples approximately tenfold descended against Kp.Simultaneously, the bed silts‘ impact on the groundwater recharge (saturated hydraulic conductivity of silt) was also examined. Determination of the total recharge amount was done by numerical simulation (model SKOKY) and by the so-called method of interaction formulas. These two approaches were applied at the Žitný Ostrov channel network. There were field measurements performed in monitored three main channels and adjacent to obtain correct input data. These characteristics were used for simulation and computation of total recharge along the channels. The total recharge amount was calculated for four alternatives of the surface water levels in the channel and the surroundings groundwater respectively. We chose four simplified variants with the same geological conditions in surroundings area of channels, only water levels of groundwater and in channels were modified. The results of the simulations seem to show greater impact of the silt in the case of outflow from the channels to the surroundings than the inflow into the channel from the surroundings.
-
The Role of the Digital Terrain Models in the Assessment of Surplus Water Risk at the Szolnok-Túri Plain
47-51Views:136The environmental factors to which surplus water can be assigned (topography, soil, groundwater, vegetation etc.) can be subject to special analysis and the randomness of the occurrences can be limited. The results of these procedures are surplus water risk maps of the areas, which can be utilised in land use planning. The risk map of the research site was created with overlaying digital category maps of the determining factors (hydraulic conductivity, convexity, critical probability of ground water level and land use).
-
Water infiltration into the soil – what do measurements indicate?
343-351Views:159Physical properties of top-soil organic materials significantly influence initiation processes of infiltration and runoff generation. This paper deals with the specifics of water infiltration through the top surface organic layer of the forest soil. Three field methods (Guelph permeameter, Tension disk permeameter, Single-ring method) and one laboratory method (Falling head) of hydraulic conductivity (KS) determination are compared and interpreted in the context of their applicability and limitations. The Falling head method provides far different values of KS if sample cylinders are or are not sealed with grease against the wall effect. The Guelf permeameter is very significant to the position of different horizons’ interface, while Tension disc permeameter results are dependent on antecedent soil moisture. The single ring method is applicable with acceptable results only when there is no abrupt interface between horizons in the vicinity of the ring bottom edge.
-
The irrigation influence under the soil, microclimate and plants in maize from Crişurilor Plain
180-186Views:104The paper is based on the researches carried out in the long term trial placed on the preluvosoil from Oradea in 1976, for establishing
the soil water balance. In the irrigated variant the soil moisture was determined 10 to 10 days for maintaining the soil water reserve on
irrigation depth (0 – 50 cm for wheat and bean, 0 – 75cm for maize, sunflower, soybean, sugarbeet, potato and alfalfa 1st year and 0 – 100
cm for alfalfa 2nd year) between easily available water content and field capacity. Thus, an average irrigation rate of 2560 m³/ha was used
in the 9 experimental crops. The average of the annual rainfall for the 1976 – 2008 period was of 625.0 mm. The technologies used were
correlated with the needes of the crops, such as melioration crop rotation, chemical fertilizers in accordance with the chemical export on the
yield, manure (40 t/ha) was used in potato and sugarbeet. After 33 years of the irrigation use the soil structure degree (38.62%) did not
decrease when compared to the unirrigated maize – wheat crop rotation (37.01%). Bulk density, total porosity, penetration resistance and
hydraulic conductivity have worse values than the ones in the unirrigated variant. The humus content is very close to the humus content
determined in 1976, the phosphorus and the potassium content increased very much in comparison with the initial content (117 ppm vs 22.0
ppm); (180.0 ppm vs 102 ppm). The use of the adequate fertilization system and of the irrigation water with a good qaulity did not determine
a decrease of the pH value of the soil. The irrigation determined the improve of the microclimate conditions, the increase of the plant water
consumption, yield gains very significant statistically and higher protein content of the maize grains.