Search
Search Results
-
The application of bentonite and zeolite for soil amelioration in acidic sandy soil
131-137Views:103In a pot experiment, we have studied the effect of bentonite and zeolite in different dosages [control; 5; 10; 15; 20 g kg-1] on acidic (pHH2O=5.65) humus sandy soil. The experiment was set up in 2007 and 2008 in the greenhouse of the UD CASE Department of Agrochemistry and Soil Science. As a test plant, perennial ryegrass (Lolium perenne L.) was used.
In laboratory examinations, pH(H2O), pH(KCl), hidrolytic acidity, nitrate-N content, readily available phosphorus and potassium content were determined. Among soil microbial parameters, the total number of bacteria, the cellulose-decomposing bacteria, the carbon-dioxide production, the microbial biomass-C content of soil, and the saccharase enzyme activity were measured. In the experiment the biomass of the test plant was determined.
The effect of bentonite and zeolite in different dosages can be summarized as follows:
− The pH increased under the effect of low dosages. With the increasing of the pH the hydrolytic acidity - at the bentonite treatments significantly – decreased.
− Regarding the readily available nutrient content of the soil, low and medium dosages proved to be effective. High dosages of bentonite treatments reduced the nitrate-N content, the readily available phosphorus, and potassium content of soil, by zeolite treatments the high dosages reduced the nitrate-N content of soil.
− Regarding the measured soil microbial parameters in both treatments low and medium dosages proved to be also effective, but the high dosages didn’t cause decreasing at the total number of bacteria, and by zeolite treatments the biomass-C content of soil.
− Also the bentonite and zeolite treatments enlarged the biomass of the test plant. We experienced significant increasing by bentonite treatments by the effect of medium and high dosages, while in zeolite treatments only the high dosage caused significantly increasing in plant biomass. The largest dosages decrease the plant biomass.
− Under the statistical analysis we found many medium and tight correlation between the studied parameters. -
Examination of compost maturity using reflectance
29-34Views:122Composting is one of the most popular recycling processes for organic waste. Composting plays an important role in waste and by-product management and is becoming increasingly important in both sustainable energy management and circular economy. Composting transforms organic matter to produce a safe and stable by-product (compost) that can be applied to arable land in a similar way to fertilizer. Physical, chemical and biological methods can be used to monitor the process and to determine the maturity of the compost, as spectrometric/spectroscopic methods play an important role in the analysis of different environmental samples.
Our aim was to (1) non-destructively detect the effects of different additive ratios on the spectral properties of the composting process and the spectral data of different compost mixtures, (2) to find the wavelength ranges of the reflectance curve (inflection points) sensitive to compost maturity, (3) to determine the correlation between the inflection points and the chemical and physical parameters measured in compost by conventional methods.
The mixture of broiler and hen manure and zeolite was composted 62 days in windrow composting. In the composting experiment, the moisture content and temperature (°C) were measured every three days and compost samples were taken and in 10% destillated aquaeous suspension were measured the pH and electrical conductivity (mS cm-1). Compost samples dried to mass stability were spectrally analyzed in the wavelength range 400–1000 nm with AvaSpec 2048 spectrometer.
Based on the results, the reflectance of mature compost were smaller in the last days of composting than the reflectance values of day 0 samples, thus compost maturity can be detected spectral in the VIS-NIR wavelength range. For the tested compost prisms, the reflectance of each sampling day shows a constant slope, with a significant overlap of the reflectance curves up to 400–700 nm wavelength range, and there was a breakpoint in the 700–750 nm wavelength range which was proved by binary encoding.
-
Examination and statistical evaluation of physico-chemical parameters of windrow composting
33-38Views:189The treatment and utilization of plant and animal waste and by-products from agriculture is very diverse. Traditional environmental management practices for waste management have been retained through soil conservation and the applied of recycle degradable organic substances in soil. The management of by-products from agriculture (animal husbandry) is important because a closed loop can be created to utilize by-products (manure, feathers) from the production of the main product (eggs, meat, milk) and to form a raw material for a new product. It is important to treat the resulting by-products, especially deep-litter manure, as it has served as a basis for compost-treated manure to develop an organic-based, soil-conditioning product line. Poultry manure by itself is not suitable as a substrate for aerobic decomposition, so it has to be mixed with other substances (zeolite, bentonite, soil), because of its high nutrient capacity, it is an acidifying substance.
The aim of this study was to compost the mixture of poultry manure and hen manure by the addition of zeolite and to monitor the composting process. It was also our aim to statistically determine the effect of the zeolite on parameters describing the composting process.
The windrow composting experiments were set up in the composting area of the University of Debrecen, Institute of Water and Environmental Management. The composting experiment was 62 days long, during which the main parameters describing the composting process were continuously monitored: temperature (°C), moisture content (w/w%), electrical conductivity (mS/cm), organic matter content (w/w%), examination of nitrogen forms (w/w%). In this study, three factors were investigated: temperature, humidity, and pH. For statistical evaluation, R software and RStudio user interface were used. We developed a repeated measurement model, in which the fixed and random effects were determined for our parameters under study, and the resulting relationships were shown on interaction plots.
Based on our results, the temperature of the prisms has become independent of the ambient temperature and the composting stages can be separated in both the control and the zeolite treated prisms. In the repeated measurement model, we proved that treatment, time and treatment: time interaction were significant at both temperature and pH.