Search
Search Results
-
The effect of the preparation method on the physical and chemical characteristics of propolis tinctures
163-168Views:278The effect of the preparation method was examined with regards to the physical and chemical characteristics of the propolis tincture, namely the extraction time and the ethanol content of the extraction solvent to the dry matter, polyphenol, flavonoid, phosphorus, calcium and copper concentration, respectively. The dry matter, the polyphenol and the flavonoid content were the lowest in the water extract of the propolis; however, significant increase was noticed depending on the extraction time. Significantly higher concentrations were found in 50 V/V% tinctures. The highest dry matter and flavonoid contents were analysed in 100 V/V% tinctures, whereas highest polyphenol content was found in 80 V/V% tinctures. However, the differences were not significant in several cases between latter tinctures. Moreover, the increase was not determined in some cases depending on the extraction time. Phosphorus and calcium concentrations were decreased depending on the increasing ethanol content, whereas copper concentration was increased up to 80 V/V%. Higher increase was found in the case of 0 and 50 V/V% extracts than in 80 and 100 V/V% tinctures. Moreover, in latter cases, no significant differences were found on several occasions, depending on the extraction time. There was no connection between the flavonoids and the calcium as well as the phosphorus content, whereas flavonoids may be made complex with copper. However, the amount of the possible complex was negligible.
-
Elemental content of propolis samples from Pest, Zala and Bács-Kiskun county (Hungary)
149-153Views:261The elemental content of 61 raw propolis samples from Pest, Zala and Bács-Kiskun county (Hungary) were analyzed by ICP-OES. The content of Al, B, Ca, Cu, Fe, K, Mg, Mn, Na, P, S, Sr and Zn were measured in the samples. Median is higher than mean in all cases based on the summarized results. It can be explained by the outliers, moreover it has a non-normal distribution. The concentrations are in an extremely wide range, the ratio of the maximum and minimum is under 10 in case of six elements, between 10 and 35.1 in the case of other six elements,and more than 300 in case of Zn. Significant differences are between counties only in the case of B, K and P based on ANOVA. Other elements have no significant differences. The following order can be set up based on the mean concentrations and the wide ranges: K≥Ca>P≥S≥Fe≥Mg≥Al>Zn≥Na>Mn≥B>Cu≥Sr. Moreover it can be established, that the measured concentrations are near the same or in some cases lower than in other publications.