Search

Published After
Published Before

Search Results

  • Active point bar development and river bank erosion in the incising channel of the lower Tisza river, Hungary
    13-28
    Views:
    205

    The development of point-bars and bank erosion are critical near-bank processes, as they indicate
    the sediment and hydraulic regime of a river system, thus, they refer to the equilibrium conditions of
    a channel. However, throughout history, rivers have been modified for various benefits which change
    the development of point-bars and the rate of bank erosion. In the Lower Tisza River (Hungary), river
    regulations influenced the channel and floodplain development, altering the natural fluvial processes.
    The aim of the research was to determine the rate of near-bank processes and to make trajectory for
    future river evolution to support future engineering works. The bank erosion and point-bar development
    at human-influenced and freely meandering sections of the Tisza River were monitored since 2011.
    Behind a collapsed revetment, the bank erosion rate was 0.6 m/y, while at a freely meandering section it
    was 2.3 m/y. The studied point-bars are located in revetted and freely meandering sections. Their surface
    eroded within the period. These intensive erosional processes refer to an incising meandering channel,
    which must be considered during future planning of in-channel structures (e.g. revetments, bridges),
    thus, geomorphic methods must be considered in any river engineering scheme.

  • Bedload transport measurements on the Maros river, Hungary
    37-41
    Views:
    162

    Sediment transport is a vital component in hydrological and fluvial geomorphological studies, however, the temporal and spatial changes in sediment fluxes, and the efficiency of bedload samplers are rarely analysed, as bedload measurements are quite difficult. The aim of the present study is to measure the bedload transport of the sand-bedded Maros River (Hungary) at low stages using the Helley-Smith bedload sampler. In order to understand the variability in the bedload transport, the water stage and discharge across the channel section were also measured. The variability of the bedload was caused by an active in-channel bar and translational sediment pulses. The created bedload transport rating curve could be applied just below 300 m3/s water discharge thus further measurements are needed to evaluate the bedload transport of higher discharges.