Search

Published After
Published Before

Search Results

  • Surface polishing method application to reduce micotoxin content of mill wheat
    339-342
    Views:
    137

    The fungi causing the infection and most of the harmful toxins they produce are concentrated in the bran of the grain, thus the intensive surface cleaning, the so-called debranning operation could allow the reduction of contamination in the milling technology. The essence of the PeriTec technology – originally developed by SATAKE, a Japanese company, to clean rice – is that it gradually removes the bran layers of the grain by mechanical means before further processing. We modeled the PeriTec technology with a laboratory size, batch-operating, horizontal debranning machine by SATAKE. The flour, milled grain after grinding 40 sec, the initial toxin content was only a small proportion (~15–20%) measured. The results showed that below the limit of DON toxin contaminated wheat (DON: 1.15 mg kg-1) during the grinding surface of the detached bran toxin contamination shows a very high (6.16 mg kg-1). The 40 seconds debranning before grinding shows lower DON toxin content than without debranning. So it is importance before the grinding. The toxin contamination of the bran fractions is significantly reduced, which is importance to the feeding point.  As a result of debranning, the toxin content of the grinding fractions decreased, which justifies that that PeriTec method is suitable for the reduction of toxin contamination. 

  • Study of effects on quality of different wheat flour fraction
    123-129
    Views:
    95

    Wheat is one of the most important cereals in the world and the bread made of its flour belongs to the everyday life of human mankind.
    The Hungarian standard relating to the laboratory production of wheat flour (MSZ 6367/9-1989) does not mention the type of laboratory mill used for milling, and it only builds up some general criteria, such as: the laboratory mill should be provided with four differently nicked barrels, a sieve with appropriate hole sizes, and also with the separated collections of the pilot flour and the bran. Our study was started at this point and the answers for the following questions were aimed to be found: do the flour patterns studied and produced with different grinding and sieving
    techniques, widely used in laboratory mills of the same wheat pattern show any alterations after the impact of the formula production as regards chemical constitutions and reologic parameters. Various flours and whole grains of the wheat patterns sieved with different particle sizes were studied in this experiment. In producing this pattern two different mill types of FQC 109 and CHOPIN CD 1 as well as two different grinder types such as PERTEN 3100 and type of RETSCH 200 were applied. There were 3 different corn sizes of 160; 250; 800 μms used in the partition of the fractions. To study the differences the following  measurements were conducted: dry matter, ash, protein content, wet gluten content, gluten index, gluten expansiveness, farinographic value, falling number and amilographic rate.
    The results this research confirm that the quality of wheat flour can be modified by different methods of pattern production. In all cases the differences can be explained by the flour-bran ratio, and in some of the cases the higher germ content of the fractions also played a role. The results show differences between the various types of mills and grinders, too.